- Sequencizer controls and panel elements are now properly positioned. (This time I really mean it.)
- Sequencizer now correctly uses the global LEVEL knob to attenuate the current step’s START and END levels.
- Sequencizer and Scannibal controls and panel elements are now properly aligned.
- Added four new multiplier ranges to Func and Func 6: 0–5, ±5, 0–10, and ±10.
- Added a signal level range to Swave, so it can now operate on unipolar signals in addition to bipolar signals.
- Updated all modules to be compatible with VCV Rack 2.
- Hid the Curve Sequencer modules from the module browser. Use Sequencizer instead.
- Updated the Truth modules
- Changed the mechanism for making a truth table depend on its previous state (Q). This change removes the A/Q button from column 1 and gives each result button two additional options: Q and ¬Q. This allows creating a state-dependent truth table with fewer columns.
- Taught the modules how to upgrade existing presets to use the new result options instead of the A/Q button.
- Added override buttons to the Q and ¬Q outputs.
- Moved each preset to the next lower-ranked Truth module.
- Added a Truth 4 preset that implements a D latch with set and reset.
- Added Scannibal 4.
- Added Scannibal 8.
- Added Scannibal 16.
- Added Sequencizer 4.
- Added Sequencizer 8.
- Added Sequencizer 16.
- Changed the presentation of “stepper” controls.
- Added three new modes to the Curve Sequencer modules:
- INPUT mode copies the IN signal to the OUT port.
- LEVEL mode copies the LEVEL voltage to the OUT port.
- CURVE mode generates a curve that gradually approaches the IN signal.
- Fixed an error in the Ranger GUI.
- Added Curve Sequencer 4.
- Added Curve Sequencer 8.
- Added Curve Sequencer 16.
- Stage, Booster Stage, and Hostage.
- Fixed a defect that prevented these modules from retriggering while a stage was in progress.
- Fuzzy Logic H and Fuzzy Logic Z
- Added a UNI / BI switch to allow operating on audio and other bipolar signals (-5V to 5V).
- The OR and NOR output port widgets for inputs C and D were incorrectly connected to the XOR and XNOR outputs.
- Added Gator.
- Added phase CV with attenuverter.
- Reordered controls to match Blossom.
- Added a CV attenuverter.
- All modules
- Added parameter tooltips.
- Added the ability to specify parameter values via keyboard.
- Renamed and reoriented the limit controls to better convey their effects on the LEVEL knob.
- Restored the shape switch.
- Added Blossom.
- Fixed a defect that caused the envelope generator modules to sometimes generate a single sample of the wrong voltage. When used to modulate volume, the result was a very nasty click. A huge thank you to Omri Cohen for finding and reporting this problem.
- Added a PHASE knob and a RATIO quantizer switch to Xycloid.